Recent content by jimmiejoe

Hello. I have started running the server again now that it has cooled off. I am getting a consistence failure returning work after it has complete. I have waited for 28 failure before restarting the server at which point it appears to sent the work with out issue and pull new work. Any...

I finally got around to doing pkill and adding the -bigadv flag, however, I got an error message after the restart, but looks like it is still running. Do I follow the error instruction or ignore it? I tried to post a pic of the error but do not seem to have the ability any longer...

The 24 core is a H8DGU-F with 6174s. Is there a good gage to determine if the bonus WU will complete based on A3 WU, or do you need to run the A5 or A6 themselves to determine if it will make it or not?

Looks like all of my rigs regardless of core count are getting A3 WU. When FAH -clientonly loaded I only saw -Verbosity 9 -smp as additional options. I was under the impression that the install would automatically add the setting for bonus work. Did I miss something? What is the latest...

Looks like my reply a few days ago did not stick. The H8DCL-6F is using a 3.5" hard drive.

I have started to setup the H8DCL-6F with 4284s and 24GB with the 12.4 image. It appears to take much longer to run through the start-up. Is this due to it being a 2P, or because the it is trying to OC or some other reason. I am definitely see more lines of text than on the other 3 installs...

The second SSD was prepped on the second host, but the error looks the same as the first host. I am guessing that it is due to both SSDs being Win7 formatted drives to start with and appears to be giving an error in the same sector area, so it could be the boundary of the hidden system...

Loaded 13.10 image. The install seems slower than 12.4, and the GUI is very sluggish.

Was running RMPrepUSB on my second Samsung SSD and got what I think is the same error as the first SSD:

Got home early today, will be away from the system for a week. I put the SSD in another host system, ran RMprepUSB with the current 12.4 image and then put the drive back in the X8STi-3F system and it appear to be behaving normally, so it is either the cable or the controller, or controller...

Thank you. I will probably need to wait until Monday to play with this more. I will try both as well as check the drive. Currently waiting for work units to complete so I can reconfigure everything and continue testing.

I installed the Samsung software on the Host machine and found that it would not except the Samsung drive, as a Samsung drive. I also noticed that the controller was set as RAID instead of AHCI, which the Samsung software does not like. Would this affect RMPrepUSB when it is putting the image...

Here is where it appears to stall after a clean install:

Unfortunately I do not remember the error clearly for RMPrepUSB. I think it was something about the disk, I assumed it was because the disk was not cleared. The second time it was claer that the disk was unmounted. I did not see the system reboot on it own, so I do not think it made it to...

How to delete this reply? edit/delete does not provide delete