g'day guys. i have a question on the fan setup on my external wc project. i was using 2x150mm fans just a few days ago and it blew up and got toasted. i am going to replace my 2x150mm fans (which is in a pull config) with the options below:
1) 2x120mm Nidec 110CFM pull and 2x120MM Adda 50CFM...
here is my customized ex wc kit, it has 2x150mm fans and a custom made rad with a dimension of 120mmx300mm, pumps are 2x1600l/h . the tubings I used is a Masterkleer 7/16" ID/ 5/8" OD. my load temps on an oc'ed A64 3200+ is 39C, 11C lower than my previous cooling which is a Thermalright XP-120...
My Lian-li V2000
been a long time since the last time that i posted here. anyway, here is my new rig:
Athlon64 3200+ Newcastle(S754) 11x215
DFI LanParty NF3 UT250GB
Geil Ultra-X 2x512MB
Creative Extigy
Logitech Cordless Freedom
HIS Radeon 9800Pro
Pinnacle PCTV
Seagate 80GB/ 200GB SATA...
been a long time since the last time that i posted here. anyway, here is my new rig:
Athlon64 3200+ Newcastle(S754) 11x215
DFI LanParty NF3 UT250GB
Geil Ultra-X 2x512MB
Creative Extigy
Logitech Cordless Freedom
HIS Radeon 9800Pro
Pinnacle PCTV
Seagate 80GB/ 200GB SATA
Seagate 200GB...
here is a good setting
Direct3D and OpenGL:
AA = 4x AF= 8x both set at performance
Texture Preference = Performance
Mipmap Detail Level = High Quality
Wait for vertical sync = Default On
Truform = Always off
this works well with the cat and omega drivers
so far the best oc'in mobo for the socket 754 is the DFI lan party ultra nforce3. i also have an MSI K8N Neo Platinum, it supports raid 0+1 and has a 450mhz fsb (bios ver 1.4)