if it's compatible with the stock Skyrim mods I'd take a shot at loading all of the high res texture packs to see what we can make of it. It's an older engine for sure but it was capable of a good amount with the proper textures loaded into it.
This isn't new by any means. Just look up old posts about the Westinghouse 37" LVM-37W3. Just more realistic of an option now with 4K to replace multiple 1080P/1440P panels.
Both my PC and Xbox 360 accepted 1920x1080 resolutions. And according to its' wikipedia page:
The Qumi can accept an input resolution up to:
1920x1080 (1080p), at 60 Hz, when using HDMI
The setup, a Hans-G 28 inch wall mounted to float above my LG 34UM95
Projection set to the wall adjacent.
The QUMI 500 Projector pushing the image
About 62 inches of 1080P goodness
The setup, a Hans-G 28 inch wall mounted to float above my LG 34UM95
Projection set to the wall adjacent.
The QUMI 500 Projector pushing the image
About 62 inches of 1080P goodness
I haven't posted since I moved back in March, and may be moving again. The setup is never finished!
Here's the setup as it currently stands. Recently acquired the LG 34UM95 and moved the 28" Hanns-G to where my old HP w2207 used to reside. Still debating if I even want to keep the Hanns-G...
No, I do not have access to the switches again until I am onsite. The issue concerning VLAN1 was confirmed from another technician who simply showed up to verify that the hardware wasn't the problem since the equipment is covered under their warranty, but as the issue was confirmed to be from...
You are probably right about that, as I said I'm not too familiar with switch configurations. I'm trying to help this guy out so if you have any tips or links that would help that would be awesome.
I have someone I'm trying to help out with a simple network that inherited some cisco switches. Apparently they were defaulted but VLAN 1 is still disabled (I understand why, not arguing that), but they need it re-enabled. I'm not too familiar with Cisco IOS as I haven't touched Cisco since...
I have someone I'm trying to help out with a simple network that inherited some cisco switches. Apparently they were defaulted but VLAN 1 is still disabled (I understand why, not arguing that), but they need it re-enabled. I'm not too familiar with Cisco IOS as I haven't touched Cisco since...