Does anyone make mounting solutions for ultrawide monitors? I plan on running a 34" LG and would like to flank it with two 24" monitors. Anyone have a setup similar to this? Most of the stuff i have seen that can do triple monitors seems to top out at 24-27".
Anybody have problems installing these? I XP or Windows 7. I tried running the disc and afterwards the software is installed but in device manager it says "no driver installed" and the keyboard doesnt work, it does light up though. I also tried all the drivers on the razer website and it doesnt...
I think anandtech had an article about how even though MLCs get slower over time, they are still way faster than a standard HDD. This only applies to the goos ones however, like the intel.
i dont know where my thread went. But like i said before.
Celeron 430 stock is 1.8GHz. This is with a Rampage Formula (dont ask why). At with FSB at 295MHz (2.66GHz cpu speed) and vcore of 1.168v, everything is fine. 299 boots and windows works for a while but it errors in benchmarks and...
I have board with 4gb of ram (2x2gb). It appears it will only run on 2N, even if i set it to 1N it always ends up at 2N according to cpu-z and everest. This is with the ram at 920MHz and its the Dominator 8500 sticks.
seems one of my sticks is dead. been running at stock speeds for a while now, had the computer off for a few days and all of a sudden it doesnt want to boot. pulled a stick of ram out and it boots, tried switching the stick and it wont boot. no matter what slot i use there is only one stick that...
i got my pentium d930 (3.0GHz) up to 4.13GHz on a reserator xt, on low settings. it is dead silent. probably get a little more out of core 2s, this presler chip can get pretty hot. i got a little more to go increasing the speed though.
thats just a length of wire with a resistor in it. if you could find the right resistor at radioshack it probably would cost the same though, or it only comes in 5-packs lol.
ok, at 4.07GHz after 8 hours of orthos the load temp averaged about 55*C. water temp bounced around between 33-35*C. idle temps are close to motherboard temp (about 37-38*C). i can probably push the clock up a little higher now.