Recent content by vietkangta

Are you out of all docking stations?

I have it set to a single channel and it still did it.

the weird part is all 3 of my android run different android os lol. Even when I get the no internet message or see the icon disconnect and reconnect my internet is working fine since it happens so quickly. I’ve Google so many hours and no one has had the same issue.

I am having this extremely weird issue here is my home network setup. I have the att nvg589 modem/router combo. I had an ASUS ac68u wired into to my modem. the nvg589 WiFi radios are disabled so i can use the better WiFi radio from the ac68u. ASUS routers are set to access point It has...

Hi to address your points - my qpi is less than 8000mt/s. It’s around 5000 - i am trying to run my ram at 1600mhz which is the rated speed of the ram. And I’m running the uncore at 2x as recommenced by people with same chip and motherboard - qpi volt is at 1.35. It appears to be more stable...

ram already running very high voltage at 1.66

My ram are running at 1.66 even though the kit says 1.5v CPU Ratio: 25 BLCK: 160 PCIE: 100 DRAm Freq: 1604 UCLK: 3207 (double) QPI: 5774 (set to lowest) CPu Volt: 1.3 Cpu PLL: 180 QPI: 1.33 (1.35 now since it just crashed with 1.33) RAM Voltage: 1.66 Everything else on auto. Ram timings ran...

sorry it was suppose to say 4ghz.

sorry it was suppose to say 4ghz.

really? I did a a lot of reading before i set it to 4ghz most people with the chip did 4ghz easily with lower voltages than me. I was under the impression that it should be easy to hit 4ghz

Sorry it was suppose to say 4ghz. i run a bit of everything For several hours . With prime95 i ran about 8 hours

Hello, im running x5690 and having this bsod occur randomly. I've ran multiple different oc stress test and they all pass fine. memtest was ran for 9 hours. i read error code ending in d1 has to do with dram/qpi voltage and ive been upping that. was at 1.33 and it bsod so now im at 1.35 I...

yea I’ve set it like that. I haven’t really tested anything beyond 3.8ghz. Basically i inputted some numberS i believe is reasonable and did some test and the machine seems stable. I just don’t have a want to tweak anything right now to get more performance. i never seen my pc temperate below...

Yea I’ve ran cinebench and plus many others just to get the low 3.8ghz lol the ability to multitask more program is a plus for this new 6 core. I don’t think I’ll raise my Vcore as high as yours lol. I’m not ready for a new potential oc yet. Lol

Yea i could probably go higher if i did more testing but testing takes hours if not days lol I’m prettty satisfy with my performance gains right now and i only upgradeD to play around during these covid times. Maybe when i get bored I’ll tinker more. The 4ghz number looks nicer than 3.8. Lol 😋...