Recent content by woppy1

i already have a Thermochill PA120.3 in my system. i have a spare 120 rad not doing anything would it hurt performance if i put it in my loop,at the minute im only cooling my cpu but i plan to put my gpu and nortbridge in the loop in the next month or so

which motherboard is the best board out of these two and which one do you think i will get the best overclock from a P6T SE or a Biostar TPOWER X58A im leaning toward the biostar because it has an extra slot between the pcie cards so when i crossfire there will be a little more air flow

i have it running on 8

i have just tried using linx and it doesnt load all my threads anyone got any ideas

i dont suppose you could give me their email address and is it only for customers in the us,im in england and i wouldnt mind changing my socket plus how did you ask them for it and how much is it costing for the socket

What would be the correct way to unistall the physx card or update the ati drivers.I have just had a nightmare with my system trying to update the ati drivers,in the end i had to format the system.Would you remove the nvidia card then uninstall the drivers?uninstall the drivers then remove the...

Im getting a new i5 750 tomorrow with a Asus P7P55D and 4gig or ram. I know every chip is diffrent but what do you think i can expect in terms of an overclock, im on a cpu only water loop with an ek supreme block. many thanks fore any replys nick

you turn it on in your nvidia control pannel

it is because you are running with physx off which is why you have a proper score.if you turn physx on it will jump up to about p12-13000 ish i wonderd why my 4870x2 was scoring p15564 which is just above my gtx275 then i got told to turn physx off on the nvidia card and then i would see my...

i have been having a few stability problems with my 955 and MA790FX-UD5 @3.8 2.2HT i wasnt sure if it was the chip or the board. so i put it in my older MA790X-UD4 and low and behold not only is the chip stable @3.8 it only needs 1.45v instead of 1.472v and it is only full loading @42c. does...

yep the graphics card the only thing i can think of, im sure i will fing out tomorrow when the 4870x2 comes.as far as i know that needs the full bandwidth to run propley

a few days ago i posted a thread about my pcie bus not running in 16x but running in 8x. i have just recived my new board MA790FX-UD5P and this one is also running @8x it cant be the same fault on two boards the only thing i can now think of is it it the graphics card (GTX275). i have started...

the wife has given me £240 for a new am3 board and some ram i need some advice on which board to have. i want 8gig of ram which takes £100 out of the equation these are the three boards im looking at http://www.overclockers.co.uk/showproduct.php?prodid=MB-110-MS&groupid=701&catid=5&subcat=1377...

well after 3 weeks i bit the bullet and went back to water dont let anyone tell you air is close to a good water setup because it aint good job i have a very understanding wife anyhow for the life of me i cant get 4ghz stable does anyone have any tips, i can boot into windows from 1.48v...

thats nowhere near as much a pain in the rear end as having to strip it down every six months and clean it out propley and to anyone that says you dont have to do it that often look at this http://www.xtremesystems.org/forums/showthread.php?t=226632