what would be a better choice, to mate with an ip35-e and a 8600?
I have an e6300 in my main computer. I sort of want to jump on a q6600 because they are cheap at microcenter, but what do you think? the e2160 is dirt cheap... is that sufficient?
I want to be able to HD dvds and blu ray...
what about the ip35-e for an htpc? I was thinking of building one and these are cheap now. If I paired that mobo with some 8600 video card, would a q6600 be overkill for a cpu?
I have the CPU fan low temp set to 40C and 40% voltage in the FanEQ control in bios... I'm running at like 21C and the fan is running at 2800 rpm making a lot of noise. Is there something I'm forgetting?
I have this problem too. I think its my motherboard. my raptor and two 500 mb seagate drives have a burst rate of 4.5 mb/s according to HD tach. It takes forever to burn a full dvd at 16x too, like 50 minutes when it should take 5.
also my usb ports are acting screwy and any time there's a...
I have 1 74 gig raptor and two seagate barracuda 7200.10 500gb drives
i was trying to transfer like 5 gigs between the barracudas and it told me it was going to take 140 minutes.
Then I ran HD Tach on them and it said the burst rate on all the drives is 4.5 MB/s
i think it should be way...
has anyone had a problem like this? I'm using an ip35pro, and I used two printers through USB, a HP p2015 and a laserjet 1320. It will print if I shut it off then on again, but only a test page and one other page that I want. after that it will just say "printing" in the que list but nothing...
my E6300 on a ga-965P-DS3 running at a 400FSB will freeze my computer running orthos for like 1 min. my memory timings are auto, vcore at 1.375. It's stepping 6 revision B2, so I konw its capable of much higher speeds. My temps weren't going above 55C.
do you think this is a voltage problem?
I remember a while back some overclocking site had a spreadsheet with a bunch of chips, their stepping, motherboards and other vital info, along with their overclock.
Does anyone remember this? If someone has a link, please post it up. thanks.
I bought a E6300 and 965P-DS3 back in august and finally got around to trying to oc it.
now as far as cooling goes, the side of my case is open and im running a Zalman CNPS7000B-ALCU on the CPU and a HR-05 on the northbridge. Im also running bios version F11.
without overclocking (266 FSB...
I've seen a few pics of a setup like this, a 30in lcd in the middle and a 20inch widescreen vertically placed on either side. I searched a bit but can't find it, if someone would post a pic of this set up i'd appreciate it.
crimany, still not working.
remote desktop disconnected
the client could not connect to the remote computer.
the remote computer is running media center, but it was working over the network.
I'm trying to connect using remote desktop to my computer from my laptop. When its connected to the internet on the same network, remote desktop works. When I connect my laptop to my verizon internet connection, it wont let me connect. Funny thing is, the host computer runs xp media center, but...
nothin for me in cali yet... for you guys who got both already, did you fax or mail the w9? I faxed it but with the volume of faxes they were getting... i dont really trust it.