Modred189
Can't Read the OP
- Joined
- May 24, 2006
- Messages
- 16,320
Here are some results I got with my recent upgrade from an 8800GT with stock cooler to an Accelero S1 rev2.
As you can see, with the stock cooler (first picture), Load temps were at 89/90 degrees C. Way too hot. And the fan never spun up (initial issues with release-date 8800's).
after switching (second picture), load temps were down near 56 degrees C. (sorry for the compression, photobucket ftl)
Not bad for $20 off the 'egg.
Test setup: See desktop in sig. Also, there was an Antec dual-pci-slot intake cooler:
http://www.bestbuy.com/site/olspage...ntec&lp=12&type=product&cp=1&id=1124432441317
blowing at it, though from the bottom pci slots. Provides some breeze, but nowhere near what a fan mounted on the Accelero would.
Test consisted of ATi tool set for searching for artifacts while Nvidia's stock Ntune software monitored the temps. I Measured for ~5.5 minutes (same time on each setup to reach max temps) untill the max temps leveled off.
Not shown on the graph is that EACH cooler takes ~10 minutes to take the card back to idle temps. !!!
A note on installation, when applying the ram-sinks, press and hold them for a good minute or two. They don't stick right away.
EDIT: Oh btw, card @ stock settings.
As you can see, with the stock cooler (first picture), Load temps were at 89/90 degrees C. Way too hot. And the fan never spun up (initial issues with release-date 8800's).
after switching (second picture), load temps were down near 56 degrees C. (sorry for the compression, photobucket ftl)
Not bad for $20 off the 'egg.
Test setup: See desktop in sig. Also, there was an Antec dual-pci-slot intake cooler:
http://www.bestbuy.com/site/olspage...ntec&lp=12&type=product&cp=1&id=1124432441317
blowing at it, though from the bottom pci slots. Provides some breeze, but nowhere near what a fan mounted on the Accelero would.
Test consisted of ATi tool set for searching for artifacts while Nvidia's stock Ntune software monitored the temps. I Measured for ~5.5 minutes (same time on each setup to reach max temps) untill the max temps leveled off.
Not shown on the graph is that EACH cooler takes ~10 minutes to take the card back to idle temps. !!!
A note on installation, when applying the ram-sinks, press and hold them for a good minute or two. They don't stick right away.
EDIT: Oh btw, card @ stock settings.