Recent content by Rocksta107

Wow, a lot more response than I expected. Cooler is a Zalman 9500 and Vcore is at 1.28v. 60c is achived running MeGUI on an H.264 encode over 30+ min. It never runs over 60 and sometimes doesn't get that high. When the room ambient goes up, it could get warmer, but likely will stay below 65 in...

Thanks. I get conflicting reports on other sites, so I want to be safe. Any other takers? What is a temp to stay below? It gets warmer here in the summer by quite a bit and I might want to keep an eye on things.

All four cores running %100 yields 55-60 C under Core Temp.

You bet you crazy Sarah Palin country 4x4 madman!

They do occasionally spike up to 59, but don't stay there.

I love [H]ardforum, I love it dearly. I just finished getting my Q6600 up to 3.0 Ghz without ever having to ask a single question. I just want you guys to know there are a few of us out there that are thankful for all the knowledge you've made available for us to grab. So much so, you're...

I have a new system that I seem to be having a great deal of trouble with. My trouble seems to be coming down to my system shorting out. It'll just turn off randomly. I've been extra careful with my standoffs, and even tried putting in some rubber washers. My shorts seem to be coming from...

Thanks for all of the replies guys. It seems I'm stuck for now but I don't think this will happen again :)

And so the man puts in his two cents. Someone else said that too. I should have been more prepared to participate in the RMA process before it all started. I guess it's a good lesson, though sadly a $150 lesson! Thanks for all of your input, if anyone has any idea as far as how to deal with the...

I edited the link so it works :)

I changed the photo link so it will work ...

Good point. Let me see if I can post this elsewhere...

I sent in a P45 Neo-3 FR this week for an RMA. Many of you here on the forum helped me trouble shoot my dead system. I got this e-mail back today: They attached this picture: I had a local vendor review the board the day before I sent the board back to MSI and they said it was...

I sent in a P45 Neo-3 FR this week for an RMA. Many of you here on the forum helped me trouble shoot my dead system. I got this e-mail back today: They attached this picture: I had a local vendor review the board the day before I sent the board back to MSI and they said it was...

I can't say for sure just by looking at the picture, but I CAN tell you that the difference in where the slit in the RAM is *DOES* signify different types of DDR RAM. DDR, DDR2 and DDR3 all have the slot in a different place to make sure that they don't end up in an incompatible slot. The only...