Which reservoir and where?

Hey everyone... I'm going to post an actual placement design for a case I'm ordering this
week. The picture is on scale to a 40dp = 1inch scale.

I am trying to figure out which reservoir to get and where to place it. I wanted initially to go with the cylindrical 80mm reservoirs that Dangerden sells, but since the heatercore I am using is so long, it will only clear me around 2 inches between the back of the core and the front of the PSU unit, so I can't place the res there.

I am stuck on either going with one 5 1/4" bay res and placing it in the ext drive bay # 3. Or I can go with a dual 3 1/2" bay res and place it in the floppies....

Or I can try to place the cylindrical res elsewhere....


My only requirement for personal taste is that everything be housed in the case... no external stuff....

And my concern is making sure where ever I place the res, it won't be prone to air being built up and degrading performance and watercooling system life span....


I am using a swifttech MCW600 rev2 pump.... THANKS AHEAD FOR THE RESPONSES...

There is also this thing which I am not too quite sure about...



http://store.pcpowerzone.com/swfbfikit.html

Comments on the Swiftech FBK525 fill-and-bleed kit ?

^bump ..