Captain Colonoscopy
2[H]4U
- Joined
- Feb 19, 2004
- Messages
- 3,861
Hiya, I recently came across a mATX SR-series case from Compaq. It came completely stripped and I'm having some issues getting the drives to seat correctly. It uses some stupid "latch" method to hold the drives in. From what I've managed to figure out you have to screw in these screw thingies and then jam the drive into the cage until the green thingies snap and hold it in. This seems all fine and good but it doesn't hold everything in very securely, especially the HDD, which is free to jiggle around. So I'm wondering if I'm missing something, drive-rails perhaps? Anybody have experience with these cases and know something I don't? I've done a whole bunch of googling and searching eBay for parts without much luck.
Here are some pictures of my case in it's current state:
Note the big stupid green latching mechanism thingy:

Here's a shot of the screw thingies:

Here's a link to HP's very helpful "How to install a HDD" page:
http://h10025.www1.hp.com/ewfrf/wc/...&product=89327&dlc=en&docname=bph03429#N10021
Here is a link to some drive-rails on eBay, I'm not positive that they are for this case, though:
http://cgi.ebay.com/COMPAQ-143856-0...ryZ42305QQssPageNameZWD1VQQrdZ1QQcmdZViewItem
Any help would be appreciated. I was thinking about jamming some silicone washers in between the drive cage and the HDD to keep it secure. Also because of the locking mechanism I can only get one screw in on one side of my fan controller.
I was going to post this in the case-modding forums but I thought you guys would have more experience dealing with these types of cases.
Thanks,

Here are some pictures of my case in it's current state:
Note the big stupid green latching mechanism thingy:

Here's a shot of the screw thingies:

Here's a link to HP's very helpful "How to install a HDD" page:
http://h10025.www1.hp.com/ewfrf/wc/...&product=89327&dlc=en&docname=bph03429#N10021
Here is a link to some drive-rails on eBay, I'm not positive that they are for this case, though:
http://cgi.ebay.com/COMPAQ-143856-0...ryZ42305QQssPageNameZWD1VQQrdZ1QQcmdZViewItem
Any help would be appreciated. I was thinking about jamming some silicone washers in between the drive cage and the HDD to keep it secure. Also because of the locking mechanism I can only get one screw in on one side of my fan controller.
I was going to post this in the case-modding forums but I thought you guys would have more experience dealing with these types of cases.
Thanks,

As an eBay Associate, HardForum may earn from qualifying purchases.