I put a new all metal Hot End on my Ender 3 V2 and it went on great. I noticed that the temp was bouncing above and below the set point a bit so I wanted to Auto Tune the PID. Seems easy but...
I am using Simplify 3D and it is simple to do but of the 6 Windows 10 Computers I have none of them will connect with the computer through a Com Port. Ether the Com Port is not there at all or the Comport will not connect or show it has no printer hooked to it.
What Am I missing here. Do I need an update, or a file or what or am I screwed?
I am using Simplify 3D and it is simple to do but of the 6 Windows 10 Computers I have none of them will connect with the computer through a Com Port. Ether the Com Port is not there at all or the Comport will not connect or show it has no printer hooked to it.
What Am I missing here. Do I need an update, or a file or what or am I screwed?