Recent content by Endurance Man

Cry more mate, or get off the internet from time to time.

That was the first plan and i may still go with that depending on how much of a mission it is to route the tubing, will have to play with it later.

Right, lemme see if i understand this: http://i4.photobucket.com/albums/y128/Ateam/Setup.jpg This will make the tubing a bit more complicated and longer but if thats whats gotta be done :). Does make sense that the Res should feed into the pump first.

There's one on every forum ;) .

Its 2v1 now :p , any reason why you would pump towards the res?

Thanks for the advice guys, moving the res higher should be easy enough, it just slides up and down on its mounts. Another question :D, would you have the fans on the bottom of the rad blowing up or on the top blowing down?

So this is my first venture into the wc'ing arena, mainly doing it to shut my pc up, its rather loud. Iv got most things sorted, just wanted a few opinions on which way i should pump the water? Excuse my poo paint skills, did this in about 2 minutes...

With the fans installed i would guess over a KG, probably about 1.3kgs

Well this rad has dimension of 40cmX13cm, maybe you could judge whether its do-able.

No, its a triple 120mm rad, think that makes it a 360mm? :D . I cant see how i would mount it on top, with that big ass fan and the power switches ect. its just to long. Im not sure whether it would fit on the back, would be a bit tricky with cables and all. Im searching the net but i cant find...

Im installing some new watercooling soon and i thought i might get a new case. I really like the look of the Antec 900, but i cant seem to work out where i would put this big ass rad :confused: . Any ideas?

The real question you should be asking yourself is why are you buying these cards . They are first generation dx10 cards, its madness. Also the first few batches of cards are based on the 90nm process, chances are they will move to the 65nm process soon after which will run cooler and probably...

http://forums.whirlpool.net.au/forum-replies-archive.cfm/607713.html

The over lap looks really small from that veiw, could u not just sand away the edge of the pcb board?

LOL, did you just say that, gotta get out more buddy, stop anaylsing the dust particles in people's pictures :D .