Hey all,
I am undervolting my 5800x on the system in my sig. Under full gaming load the power draw is 145w.
Is that normal?
Temp is 85c.
Also if there is anyone in the community that has a similar setup and would be willing to share their BIOS settings and results I would be eternally...
Hey guys I think there is an issue with my current board and I cannot control the RGB ram kit at all. Its not even recognized by different software.
I tried a different ram kit.
I have uninstalled multiple times.
I have upedated the bios etc. cleared the cmos.
I have an ticket open with...
Hey guys,
so I tried updating the RGB Fusion software as the colours were off on my G.Skill TridentZ 32 gig kit of rgb 3600 ram. Now the software does not even "see" the ram? I have updated the bios etc but to no avail.
I even tried OpenRGB and it said it could not read info for the ram...
Not sure if this is the right section for this but, I cannot get AURA Sync to control things. Standard aura sync will not install properly and the aura creator through the armoury crate does not seem to work properly either. HELP!
Hey guys,
ok so I have tightened the block as much as possible. The temps seem shit. I have hwmonitor running and the minmax is the following and Im just on desktop no games streaming some youtube, min is 30c max is 67c.
The rad is in the top of the case with 2 x 120 mm fans blowing through...
Hey guys,
my rig is in sig, I was just chilling with chrome open watching a youtube video and my pc shut off. When I restarted it, it fired right up but a bios message said that a cpu over heat threshold triggered the shutdown.
With the watercooling I never get above 70c(idle is between...
Hey guys,
I have spent a tidy sum getting my rig up to speed lately. But, I find that the sticker on my Barracuda nvme drive is spoiling the show.
Now I realise that I can remove the sticker but, has anyone here thought to dress it up with a cool head spreader or something?
If so please add...
Hey guys,
I recently completed my rgb setup but unfortunately they came with poorly placed stickers in the middle of the fan which has resulted in a wobbly look on 3 of them.
I tried to use a sharpie on it while its spinning but that made almost no difference. I am pretty sure I am not the...
Hey guys new to this. Can I plug and rgb fan into a 4 pin plug on the motherboard for a power source but, then plug the controller into the proper controller hub?