CPU Ratio Setting: 8.0
FSB Strap to North Bridge: 333
FSB Frequency: 400
PCIE Frequency: auto
DRAM Frequency: DDR2-800
DRAM Timing Control: Manua
--DRAM CAS# Latency: 5
--DRAM RAS# to CAS# Delay: 5 DRAM Clocks
--DRAM RAS# Precharge: 5 DRAM Clocks
--DRAM RAS# Activate to Precha: 18 DRAM Clocks
--DRAM Write Recovery Time: AUTO
--DRAM TRFC: AUTO
--DRAM TWTR: AUTO
--DRAM TRRD: AUTO
--DRAM TRTP: AUTO
Clock Over-charging Mode: 0.80v
CPU Spread Spectrum: DISABLED
PCIE Spread Spectrum: DISABLED
CPU Voltage: 1.30v
CPU Voltage Reference: AUTO
CPU Voltage Damper: ENABLED
PLL Voltage: 1.58v
DRAM Voltage: 1.9v
FSB Termination Voltage: auto
North Bridge Voltage: 1.41v
North Bridge Voltage Reference: AUTO
South Bridge Voltage: auto
and im going to do the pencil mod first
sounds right?
About --DRAM RAS# Activate to Precha: 18 DRAM Clocks:
on my BIOS I can't set it higher than 15. Can you?
Also don't forget FSB, say, 1.36V.