CoreTemp Q6600 idle stock readings

[vietpho]

This is going to be hard to describe but I'll try.

Basically, I have two harddrives.
Raptor X 150GB (Same as yours)
and
Maxtor 500 GB


Chapter 4 - Unique Features
4-1 Xpress Recovery2

Basically, this is the step where I installed Windows XP and Partitioning the Hard Drive.

I think I did something wrong in this process because after I loaded onto window XP and checked "my computer", it only showed 1 harddrive.
Here are some screen shots to show you my confusion:

I think I formatted the Hard drives wrong or something because the "partition" says I have 120gb unallocated.

And I think it's the maxtor drive in that thing... isn't it suppose to be my Raptor?

Also, I ran coretemp and here's a screenshot. The cores were reading from 34-38 degrees C.

What's with TJunctions reading 100 degrees C though? Is that bad?

 

[vietpho]

This one has Speedfan readings too!

This screenshot consists new readings after I've set the Scyth fans on my Heatsinks at 100%

 

[engiNURD]

To recap our AIM convo, you need SP2 installed.

TJunction is used to calculate the temps, IIRC.

Your temps look fine.