Found some new stepping 6000+

[!gOtVolTage!]

Stepping is higher than what ive seen on the 6400+ if im correct. My new 6000+is

CCB8F-0728GPMW

Ok 6000+ screenie @stock for Burn in! I will be shaving the IHS and overclocking it to the hilt on my water set up . Im just making shure its 100% buned in and stable before i Crank on it.

Its just like building a RaceCar ,Fire it up give a few pulls and if she wants more Start Cranking up the Juice

Below Screenie @26c room Ambiant temp! thats about 79-80,farenhiet.My first 6000+ was @ 35c idle @26c ambiant. So it seems the New 6000+silocon is a lil better too. I will see next week after i tweak my water set up around again thats for shureAfter the weekend ill probly start Cranking the FSB and Vcore!

Big NOTE: The new stepping came in a Box with new GOLD TAMPER LABEL . The OLDER BOXEDChips that were in stock had the basic tamper label with no GolD circuit print. Even Better AMD revised the HEATSINK with more copper in the base ,, The copper strip that holds heatpipes is now wider "I compared my 2month old 6000+heatsink against the new6000+heatsink!"

Ive already seen a few of the new BlackBox 6400+ hit 3.6 with air and 4.1ghz with chilled water stepping of ACB8F-0723SPMW and CCB8F-0726XPMW im ^praying^ my new 6000+ stepping is as good I shall keep you all imformed on my progress.

 

[mpcamer1220]

Why is it still at stock..

 

[w1retap]

He says he's doing burn in, and he will update us with progress. Did you even read what he wrote?

 

[mpcamer1220]

He says he's doing burn in, and he will update us with progress. Did you even read what he wrote?

Yes, I read it all.. I am telling him to hurry up.

 

[pxc]

Is it a ADX6000IAA6CZ or a different model? http://products.amd.com/en-us/DesktopCPUFilter.aspx still only shows 1 model of the X2 6000+. The 89W versions aren't supposed to come out until some time between Oct-Dec.

But a better heatsink doesn't really point to a lower TDP processor.

 

[aggr1103]

What's stock voltage on these bad boys? I just checked and my bios set mine to 1.4v auto. Seems like 1.35 would be stock, but I wanna make sure. Idle temps are 40C with zalman 9500.