Need help with ATi Tray Tools and new X1950XTX!

U

Un4given

Gawd
Joined
Nov 8, 2003
Messages
779
Okay, here's the deal. I normally don't install the ATi control panel or CCC, and just Tray Tools to make my adjustments. Unfortunately Tray Tools doesn't seem to make the clock speed adjustments when a 3D application is installed. I checked all of the settings I could find to see if there was a simple checkbox for this option, but I couldn't find one. I know I could simply make an OC profile that adjusts the clocks to this setting, but I don't think that would help with the additional voltage that the card supplies when it goes to this 3D mode.

If I remove Tray Tools and just run the CCC then I get my 3D clocks.

Can anyone help with information on making the proper configurations in Tray Tools so I can get rid of the CCC. HEEELLLLP!!!
 
Never mind. After some more additional searching and finding the support pages for ATT over at Guru3D, you do in fact have to make an o/c profile with increased voltages.
 
You must log in or register to reply here.
Back
Top