Post your air cooled idle and full load temps.

S

s-other

Weaksauce
Joined
Mar 9, 2004
Messages
66
Just wondering what everyones temps are. I'm at 38C idle and 45C full load. :D
 
idle: CPU/System 43/47

load: CPU/system 49/48

setup:
A64 3200+
256MB GEIL PC3500 RAM
Chaintech ZNF3-150
Sapphire ATi Radeon 9800PRO 128MB

everything @ stock voltages and clockspeeds.
 
Idle: 45C
Load: 50C

Athlon XP Mobile 2600+ @ 2500 MHz 1.750 Vcore 2.7 Vram
Zalman CNPS AlCu 7000
 
ATM, I am clocked down to 216x9.5 (its hawt in here!) at 1.65v (probly go lower, just went for sure stability, this isnt normal settings)

I'm running with my 200cfm 120mm turned down.

Load temps:

Case: 33
CPU: 41
Mosfet/Psu area: 38


Idle temps: ??? (F@H)
 
I miss my Prommie :(

@Idle:
Case: 36*C.
CPU: 43*C.

@Load:
Case: 41*C.
CPU: 53*C.

Those are ABIT temps :)
 
Chicken Penni Pasta said:
I reccomend people also post their roomtemps, otherwise it's pointless.

39/52
and my room is 76F
Click to expand...

if so, use the same metric :p

btw, its about 24c right now here
 
34C Idle
43C Full

on the cpu is a sp-94 heatsink with a 92mm panaflo

Right now the room is at about 24C, and my case is at 27C

the case has 3 80mm pulling in the from the ground, a 60mm blowing out on the back, and 120mm panaflo blowing out on the top
 
CPU 36 Idle/50 load

ambient is about 25C year round

===========
2.4C oc'd @ 3.3Ghz
Vantec Aeroflow2 fan + Arctic Silver 5 grease
Asus P4P800 mobo
2x512 Geil PC3200 RAM (2.5 3 3 6)
GF4 Ti4600 (eyeballing 6800GT or X800 pro) :)
 
Athlon 2000+ stock, stock voltage @ 1667 ghz.
With standard retail box AMD fan I was at 50C idle, 61C full load.

Now have Vantec Aeroflow HSF, and get 40C idle, 47C full load, talk about a difference :)
 
P4 2.4B @ 2.8 with a ThermalRight SLK-947U and generic 80mm
Readings from thermistor thermal taped to bottom of the processor

Load: 52.9C/127.9F
Idle: 27.4C/81.9F

Room temp about 25C/75F
 
The temp sensor on the K8N mobo seems to be dodgy as my cpu temp goes upto 67c load! This is about 20c higher than my K8T reported. Also I dont think prime would be stable for an hour @ 67C...

CPU =A64 3400 @ 2420mhz 1.6v - 43 idle/61c load
GFX = X800pro @ XT 585-575 1.55vgpu = 30 idle/53 load (speeze amd heatsink)

Room temp is 26C and case is 28C.
 
I swapped the fans round the right way... front to back.
Added 2x 80 MM fans in the 2-wide open 5 1/4 cdrom bays, added 1 x 120MM on the side right in the middle of everything.

total: 4 x 80MM front blowing in, 2 in the empty CDROM bays, 2 in the bottom of the front, across the hard drives.
2 x 80MM exhaust, out the back near the CPU
2 x 80 MM push/pull in the power supply
1x120MM blowing in the side of the case.


temps:

39C idle, 44C full load for 5 hours.
chipset temp stable at 89-90F.
 
My AQXEA 2500 did 33/38C at stock speeds and voltages (as measured by the Asus onboard thermal diodes) with mobo temps at ~20C (I have lots of airflow in my case). That was using OCZ5+ (= AS5) with a Rev 1 Vantec Aeroflow.

200x11 @ 1.65V (rock solid) was only 38/45C, and ~25C mobo.

Now running 192x12 @ 1.75V and getting 40/50C. Mobo temps get up to 27C under load (1.7V NB, but should be decreased).
 
[email protected] 1.77V Bios/1.65V Real Thermalright SP94/92mm Tornado on low speed all fans also....

CPU: Idle 33C/36C Load
Case:Idle 24C/27C Load

Chieftec INfinity midtower case with wire management...........
 
My 2.6 @ 3.0ghz celeron
-(5v stock)
25c Idle
48c load
-(fan turn off)
33c idle
55c load

My 3.0 @ 3.4 P4
-(12v stock)
35c idle
55c load
 
You must log in or register to reply here.
Back
Top