Problems with Vaporchill neo2 plat, 4000+ SD

G

Gadfly

Limp Gawd
Joined
Jun 16, 2004
Messages
231
I just got my Vaportchill all up and running, but I am having problems determining chip tempature and the auctual chip voltage.

It seams no matter what I set the voltage to in the BIOS, MBM5 and CPU-Z report the voltage much lower, which is correct? Suggestions?

The second problem is tempature. The BIOS, and MBM5 report irratic tempatures, from -100'C to +220'C, and they never are the same

The Vaporchill reports a steady -47-49'C evaporator temp, but I know the delta between the evaportator and the core is not 0' C. Any help here?
 
i don't think the Neo2 offically supports your processor yet. I emailed MSI a couple of weeks ago asking about a new BIOS with Rev. E support and this is what they sent me-

Message
>
> Dear Customer,
>
> Currently are Taiwan office is testing the Venice and San Diego core
> cpus with this motherboard, once they have finished testing these cpus
> with this motherboard, they will have a bios update to support these
> cpus, or this motherboard will not support these cpus, after they are
> done testing. Currently there is no estimate time when the testing
> will be done.
>
> Sincerely,
> Technical Support Division
> MSI Computer Corp.
> MSI Platinum Series Motherboards -- In Pursuit of Quality Perfection.
> [1]http://www.msicomputer.com
> 1.626.913.0828
> 1.626.581.7721 Fax
 
You must log in or register to reply here.
Back
Top