June 3rd, 2004: Materials
Got some of the major materials for my case project.
-3ft x 4ft sheet of acrylic
-6ft of L-shaped aluminum
-two sawhorses (I ran out of work tables. This seemed like a good solution)
-four clamps
I already have all tools needed, except for some dremel rotary bits.
I still need to pick up extra glue for my glue gun and a couple other very minor things.
June 6th, 2004: The Plan
I've never put a whole lot of stock in the importance of cases. If a case had plenty of expansion bays, a removeable motherboard tray and wasn't razor sharp it was good enough for me.my current case , an ugly holdover from a K6-2, meets these requirements easily enough.
But it's summer time. Classes are done, my friends are either out of town or working most of the day, and I only work nights and sundays. Lots of time to waste and I need a project to waste it on.
Here's what I want to do with this case:
-I want it to be shiny. I love shiny things.
-I want it to look slick and professional. I want it to look as much at home on the desk of a professor as on the desk of a gaming enthusiast. No overabundance of glowing lights, no glowing water reservoirs, and subtle (if any) artistic flourishes.
-I want the motherboard side of the case to open up the same way the original blue macintosh G3's did, so the motherboard is easily accessible without removing a tray.
-I want it to be a decent bit smaller than my current 19" ATX case, but still contain a full-sized PSU, at least two 3.5" bays and at least two 5.25" bays.
-I want it to be quite 'stealthed'.
Pictures and updates will follow as soon as I start work.
Erik
Got some of the major materials for my case project.
-3ft x 4ft sheet of acrylic
-6ft of L-shaped aluminum
-two sawhorses (I ran out of work tables. This seemed like a good solution)
-four clamps
I already have all tools needed, except for some dremel rotary bits.
I still need to pick up extra glue for my glue gun and a couple other very minor things.
June 6th, 2004: The Plan
I've never put a whole lot of stock in the importance of cases. If a case had plenty of expansion bays, a removeable motherboard tray and wasn't razor sharp it was good enough for me.my current case , an ugly holdover from a K6-2, meets these requirements easily enough.
But it's summer time. Classes are done, my friends are either out of town or working most of the day, and I only work nights and sundays. Lots of time to waste and I need a project to waste it on.
Here's what I want to do with this case:
-I want it to be shiny. I love shiny things.
-I want it to look slick and professional. I want it to look as much at home on the desk of a professor as on the desk of a gaming enthusiast. No overabundance of glowing lights, no glowing water reservoirs, and subtle (if any) artistic flourishes.
-I want the motherboard side of the case to open up the same way the original blue macintosh G3's did, so the motherboard is easily accessible without removing a tray.
-I want it to be a decent bit smaller than my current 19" ATX case, but still contain a full-sized PSU, at least two 3.5" bays and at least two 5.25" bays.
-I want it to be quite 'stealthed'.
Pictures and updates will follow as soon as I start work.
Erik