I want to run a XP-M 3000+ on my nforce 2 board (Chaintech 7NJL6). This board says unknown CPU, then clocks it at 133x6. The bios won't let me adjust the multiplier. It should be set at 133 x 16.5. Any ideas on how to get the proper setting using this board?
I read on the IntraWeb that if I break the 3rd bridge from the left on the L5 block, I will convert this chip from a mobile barton, into a desktop barton. Would this board then read the timing correctly?
Any help would be appreciated, thanks.
I read on the IntraWeb that if I break the 3rd bridge from the left on the L5 block, I will convert this chip from a mobile barton, into a desktop barton. Would this board then read the timing correctly?
Any help would be appreciated, thanks.