should i prep it in a special way?(i doubt sanding since it's gonna be bare aluminum inside *suppose*) How do you heat a spray can, and why does it work better?
well imho you don't need to sand the inside of the tower, just be sure it's clean.
it's better to use warm paint because it flows better and you get a better spreading.
just put it on the heater for some time, but be careful, when it gets too hot, your room will look a lot darker than before..
Also the rail idea is just insane. It looks so perfectly done, did you do it yourself, the plexy rack for it and all? The copper is bent perfectly also... How did you do it?
well a friend did it for me, he's a mechanic and has some better milling equipment than i have
Does the copper block(with the wire connected to them) are stuck in place or can move freely, because i don't see anything that tightens them. One side has a big hole to make no connection and the other one just fit nicely on it, is it enough to hold them in place?
it stays in place just because of the friction between rails and copper block - that high friction is also needed to conduct enough current btw.
great mod! but you put even more ideas in my head for when i'll get my case... which isn't good because i dont have anything to make what pops in my mind
well i didnt have a plan for my setup either - it just grew as i moved on :]