Rocketfish and Lian Li Aluminum Casters

If they don't fit you can just drill a few holes and screw/bolt them on.
 
Ah... I was afraid of that. Sadly, this has been the nicest case that I've owned yet and I'm very reluctant to start drilling or cutting anything at this point. :(
 
measure twice, cut once. you'll be fine with drilling and screwing them on.
 
lol, it's the bottom of the case. It isn't going to hurt anything anyway. Just buy them and do it. This is the case modding forum. If you need instruction we can help if you need it. If you did need to drill holes, I'd say 4 small holes through both the brackets and case bottom, then bolt them up with short bolts/nuts/washers. It would be clean and very simple, only taking about 10 minutes.
 
Alright sounds good. I will buy them and see how things work out. Thanks everyone! :)
 
You must log in or register to reply here.
Back
Top