ok im starting off with a lian li V2000 case that will house 3 water loops much like TN project. im not going to talk about the water set up right now i will touch on that when i start puting evry thing back in to the case.
the low part of the case psu and hard drive mounts have been removed as well as the center floor of the case. they are going to be replace with 1/4 plexi.
i was going to window the side for the case so you could look in but after an hour of hacking on my case side i gave up. so this is what i came up with i picked up a piece of 30x36 1/4 plexi marked out a new case side and cut it out. added the mounting rails for the case rounded the corners and bam new case side.
im up loading the pics to my host site now so they should be up in a few min
the low part of the case psu and hard drive mounts have been removed as well as the center floor of the case. they are going to be replace with 1/4 plexi.
i was going to window the side for the case so you could look in but after an hour of hacking on my case side i gave up. so this is what i came up with i picked up a piece of 30x36 1/4 plexi marked out a new case side and cut it out. added the mounting rails for the case rounded the corners and bam new case side.
im up loading the pics to my host site now so they should be up in a few min