Does anyone have any suggestions where they think I can improve any voltages or speeds? My chip and mobo have a hole around 2.7-2.9Ghz and when I tried going over 3 it didn't seem to stable. I had set my voltage up to 1.46 or so and have worked down from there. It took that much just to reach 3.0 and break it in.
My Rig (Pic posted at bottom):
Intel Q6600 @ 2.4GHz GO Stepping
VID: 1.32500 (sucks)
ASUS P5N32-E SLI 680i
OCZ Platinum 2x1GB PC2 6400 4-4-4-15-1T @ 1.8
BFG 8800GT OC 512mb @ 625core
74GB W.D.10000rpm Raptor +
250GB W.D 7200rpm
OCZ GameXtreme 700W PSU
Overclock:
Voltages
1.2VT @ 1.35v
NB @ 1.35v
SB @ 1.5v (lowest setting on mobo)
CPU VTT @ 1.35
Memory @ 1.9v
CPU
Intel Q6600 @ 3GHz 1.368v in BIOS
333x9 FSB
Idle
3GHz @ 1.360 in CPU-Z
Temps 34/33/25/25
Load
3GHz @ 1.344v in CPU-Z
Temps 40/40/33/34
Memory
4-4-4-12-1T @ 333MHz (1:1 ratio)
Video Card
625/1566/900 @ 675/1688/960
60% Fan 54C Idle/65C Load
Cooling:
Swiftech Apogee GTZ Waterblock
Swiftech MCR220 Quiet Series Rad + AF PWM 120mm Fans x2
Tygon 7/16ID 5/8OD Tubing
Bitspower Compression Fittings
Danger Den CPX-Pro Pump + Swiftech Res
My Rig (Pic posted at bottom):
Intel Q6600 @ 2.4GHz GO Stepping
VID: 1.32500 (sucks)
ASUS P5N32-E SLI 680i
OCZ Platinum 2x1GB PC2 6400 4-4-4-15-1T @ 1.8
BFG 8800GT OC 512mb @ 625core
74GB W.D.10000rpm Raptor +
250GB W.D 7200rpm
OCZ GameXtreme 700W PSU
Overclock:
Voltages
1.2VT @ 1.35v
NB @ 1.35v
SB @ 1.5v (lowest setting on mobo)
CPU VTT @ 1.35
Memory @ 1.9v
CPU
Intel Q6600 @ 3GHz 1.368v in BIOS
333x9 FSB
Idle
3GHz @ 1.360 in CPU-Z
Temps 34/33/25/25
Load
3GHz @ 1.344v in CPU-Z
Temps 40/40/33/34
Memory
4-4-4-12-1T @ 333MHz (1:1 ratio)
Video Card
625/1566/900 @ 675/1688/960
60% Fan 54C Idle/65C Load
Cooling:
Swiftech Apogee GTZ Waterblock
Swiftech MCR220 Quiet Series Rad + AF PWM 120mm Fans x2
Tygon 7/16ID 5/8OD Tubing
Bitspower Compression Fittings
Danger Den CPX-Pro Pump + Swiftech Res