Recent content by bhag

I just received E0 E8400 from Newegg.

Thanks for the reply. Not sure about the SPD. Yes I get no beeps with no ram/vidcard. I bought a new mobo thinking that was the most likely culprit and have the same issue. I think I need to start over at square one and go through all of these steps again maybe on both motherboards. I...

RAM is GSkill in my sig. I'm having the same problem with two different motherboards. I took the RAM out just to see if my motherboard would give me any beeps/response with just the PSU/CPU/heatsink/fans. No response or beeps, just powers up the shuts down then repeats. Didn't work with the...

Problem: Computer wouldn't post/boot. Monitor/keyboard/mouse not recognized. Would power up then shut down then power up, etc. Ordered a new Gigabyte UD3P thinking my mobo was dead. Installed. Same problem as above with only PSU/CPU/heatsink/fan/RAM. No beeps just powering up then...

OK if I'm doing this correctly I'm getting voltages of 9v yellow 2.5v red 1.5v orange So it looks like it's my PSU eh? This is with a non-digital meter.

How do I test the PSU? Unfortunately I don't have an extra one around. I used a paper clip between pins 14/15 and the PSU powered up and fans came on... this was with motherboard removed. This is the only thing I could find on the forums about testing a PSU. Anything else I can do to test...

Tried this morning pulling out the ram... no beeps at all. It powers up... no beeps... shuts down... repeats. Just the essentials plugged in. Pretty much runs for a few seconds and shuts down. Any thoughts? The problem is this is the exact issue I was facing with my last motherboard...

Thinking my previous motherboard went out, I just installed a new Gigabyte UD3P with system below. My computer won't boot... monitor, mouse, keyboard won't respond/aren't recongnized. Powers up, fans run, dvd lights up and that's about it. After it sits for about a minute or two it...

Pic please. :)

I believe I used 6-32 x 3/4".

Take a look at this thread and this one.

I'm at work and can't do a measurement but the thermochill pa is thick (50mm if I remember correctly - please correct me if I'm wrong). I have a Swiftech 120.2 (34mm) up there like Dutt and there is some space between the radiator and the top mesh. I think you would be cutting it very close...

I have my cpu watercooled so I needed a little different airflow to keep my NB and memory cool. I have the front and back fans as intakes and the top two fans as exhaust. Working well for me. EDIT: After further testing I have switched the back fan to exhaust - cpu temps went up with it as...

Lol, I'm sure it happens to a lot of us - I thought it was just me. Building my recent comp I received a E6600 (RMA) with a defective contact pad, basically scratched off, GTS (RMA) secondary to fan trouble, fan controller with a burned out resistor... but I've been on a little lucky streak...

This seems kind of minor now doesn't it.... compared to the previous pics lol. :D